Four inch homemade maf

[TTA976]

Better new pic.

 

[GNX077]

so your not running a mas....?

 

[tta299]

sweet i got a full metal pipe like that but cant run it until i get the fast xfi on it

 

[jarredsoon]

sweet i got a full metal pipe like that but cant run it until i get the fast xfi on it

Where did you get that from?

 

[TTA976]

so your not running a mas....?

No. I am using Eric's Speed Density chip. You need a Powerlogger to run SD... Nice not have to deal with the extra plumbing of the maf sensor.


Joe

 

[tta299]

Where did you get that from?

I got it an alot of other parts u see under the hood from julio aka razor off his Alky test mule .... If enough people are interested im sure someone could make acouple

 

[robert lee]

No. I am using Eric's Speed Density chip. You need a Powerlogger to run SD... Nice not have to deal with the extra plumbing of the maf sensor.


Joe

are you using a 3" inlet bell? :read:

 

[TTA976]

are you using a 3" inlet bell? :read:

No, I have the "S" (4" inlet) cover on my Tnetics 6665.


Joe

 

[jarredsoon]

JOe waht intercooler is that in your car?? A Jim Dunn/Mease?? Did you paint it??

 

[TTA976]

JOe waht intercooler is that in your car?? A Jim Dunn/Mease?? Did you paint it??

Yep. I painted it with hi temp black tractor paint. Everywhere but the fins. You might be looking at the blueish coupler attached to from ic to the up pipe. That's not the worst part. The bottom 2 t-bolt clamps are labeled Ford Motor Company.lol

Made the maf pipe like this because it clears the ic pipe. The aeroduct hose is flexible but lays solid between the two aluminum pipes on each end. Plus $, I didn't need to relocate the IAT because of the short curved turn pipe leaving the turbo. You can really hear the turbo sucking the air in now...without any screen restriction.

I've seen custom intake pipes with pvc and duct tape..so this is good.lol

That 4" polished aluminum pipe is the tits posted above from tta299.

 

[TTA976]

Jason will say I've had more chips and maf pipes then brains.lol

I like it alot.

I found this at the local airport where I deliver too. Customer just gave it to me and I cut to fit.

Finally, I found something that does not look Butcherous.

???

Joe