3 hours and 4 stitches later

[Quiky One]

the valve covers are off. What a bitch. If I could go back I wouldn't do it again.

Why don't I have the internal baffles??

 

[simo]

Where's the blood?:devil:
I do see sweat and tears!:cry:

What finger got sliced?

Well at least you're out of school to recover.

 

[Quiky One]

Where's the blood?:devil:
I do see sweat and tears!:cry:

What finger got sliced?

Well at least you're out of school to recover.

Strangely enough the back of my hand...hand got pinched and I couldn't move it. lol

School starts back Monday. :sleep:

 

[simo]

Strangely enough the back of my hand...hand got pinched and I couldn't move it. lol

School starts back Monday. :sleep:

Ouch and Ouch, here I thought you were done with school until the fall....

 

[TTA976]

:idea5: While you can the valve covers off...

 

[Quiky One]

:idea5: While you can the valve covers off...

That is too high tech for my slow shit.

 

[Quiky One]

Big thanks ro Rich for hooking me up with the gaskets and grommets (I'll kill ya if they leak...) and the torque specs!

Got it done in sparkle silver. Looks sweet in the sun! $50 for the valve covers and plenum.

Jim is hooking me up with a powdercoated throttle body and it has been ported and matched to the new plenum along with relocating my IAT. Should be nice when completed! Rich also hooked me up with new studs to hopefully fix my intake leak that has plagued me since the powerplate install.

Jason

 

[Quiky One]

Out with the old and in with the new!

 

[Rodimus_Prime]

where can you get the valve covers with the breathers?

 

[Quiky One]

where can you get the valve covers with the breathers?

2 drivers side valve covers. Breathers from metcomotorsports.

 

[TTA976]

Looking good Jason! ttarider

 

[Rodimus_Prime]

is there anyplace that even sells the valve covers anymore?

 

[Quiky One]

New? I don't think so...

Any junkyard should have them though. Any front wheel drive 3.0 will fit.