drivers seat track covers?

[Coltsfan1]

Ok it's been 8 months since I gutted the interior of h/t 189 I just started putting her back and can't find or remember if there are drivers seat track covers? ??? I have the ones for the pass side. Can anyone advise or attach a pic? It was real late last night when I quit but I didn't swe any screw holes. :blink:

 

[8289ta]

I think IIRC they are just round covers that go on top of the bolts. They are tough to find also, and if you aren't careful removing them you can ruin the metal retainer inside.

 

[Jan Larsson]

You are looking for GM 10103705; I got some photos somewhere I can post for you when I found them.

Long gone but there's some floating around out there I'm sure.

The 4th Gen seats I believe used a very similar cap ...

 

[Jan Larsson]

Pics

 

[Coltsfan1]

Jan once again u come to the rescue. I should just get ur cell number and quit wasting:sick: everyone's time reading my posts lol. I have them I must have been in zombie mode last night. Thanks :drag:

 

[Ozpont]

I can make those if really needed...???
Also just did the little armrest black sleeves for the 3rd gens..not TTA's but of use to somebody. Should really do the TTA upper armrest to door trim bezel too.. think Jan mentioned those to me a few years back.
Just completed the Beechwood GTA/TTA Sill plates..(plus other colors for 85-92F body) (GMRP approved) due and also made the specific Beechwood rear trim screws the GTA/TTA restorers.

 

[8289ta]

Nice stuff Dave!